Laser fabrication · 5 minute read

Laser kerf versus offset: measure a test cut and avoid double compensation

Short answer

Kerf is the full width removed by the beam. The geometric path offset is half that width. An uncompensated 20 mm square measuring 19.8 mm implies 0.2 mm kerf and a 0.1 mm outward offset.

A press-fit joint can fail even when the drawing dimensions look right. Measuring your own uncompensated test cut gives a useful starting point; a different material, focus or axis may need another test.

Use the related toolLaser kerf & offset
Open tool

Use the measurement direction for your feature

For an outside part, subtract measured size from nominal size. For a hole, subtract nominal size from measured size. A 20.2 mm hole on a 20 mm nominal path indicates 0.2 mm kerf. Measure between opposite parallel edges, with existing compensation disabled.

If an outside part is bigger than nominal or a hole smaller, do not take an absolute value and trust it. Check the measurement, compensation and machine scale first.

Choose geometry adjustment or software offset

For a target 30 mm outside part with 0.2 mm kerf, use an uncompensated 30.2 mm path or a 30 mm drawing with a 0.1 mm outward offset. For a 30 mm hole, the uncompensated path becomes 29.8 mm.

Apply only one method. Software may interpret a kerf field differently from a path-offset field; inspect its documentation and preview. This calculator reports magnitude, not a universal signed setting.

Repeat the test when the process changes

Material thickness, speed, power, focus and beam shape affect the measured result. A rectangular spot can give different horizontal and vertical values. Test-fit a representative joint before using a whole sheet.

Kerf compensation does not resize joints for a different sheet thickness. Adjust tab and slot design for actual material thickness as a separate step.

Official and technical sources